Boxertony

UK Washer - Tripping the Electrics (Plugs?)

    Recommended Posts

    I have brought over my brand new un-used Washing Machine and Tumble Dryer from the UK. But I have a problem. I cut of the pre-moulded UK plug and changed it to the 3 pin Ozzie plug, but it tripped the switched. Went back to Bunnings and changed the plug from a 10 amp standard ozzie plug to a 15 amp ozzie plug one. Only to realise that the pins were to big for my sockets, thus I went back to Bunnings, got the smaller pin 15 amp ozzie plug and yet again it always trips my main switch.

     

    I put the English plug back on with the right fuse and used it with an adapter and it still tripped also tried it with a extension socket and it still tripped.

     

    Not sure what to do? Any advice will be very much appreciated.

     

    Tony

    Share this post


    Link to post
    Share on other sites
    Guest philnjulie

    have you tried another appliance in socket outlet on wall problem may be here and not with washer try plugging in somewhere else

    Share this post


    Link to post
    Share on other sites
    Guest nishman

    We had a problem in our last rental that the laundry power point was taken off of the "ring" in the kitchen. So if you tried to run the toaster or the kettle and the washer it tripped the breaker.

    As suggested, I'd try another (lower powered) appliance in the socket and try the washer on another.

    Share this post


    Link to post
    Share on other sites

    Dean, I got an electrician out and he said that he needs to wire a new 15 amp socket, which will cost about $350, therefore with it being rented we are going to leave it and eventually get a Australian Washing Machine. hopefully we can sell our new washer.

     

    Tony

    Share this post


    Link to post
    Share on other sites
    Guest Roon

    Hi Tony,

     

    I am a whitegoods engineer from the U.K. and may be able to help. What make is the washer and does it trip as soon as you switch it on or when it has been on for a while?

     

    P.S Aussie front loaders are rated the same as U.K ones, i.e the still have a heater. Toploaders are rated at about 5 Amps because none of them have heating elements but I suspect you will be disapointed with the results after using a front loader.

     

    Cheers,

     

    Daz.

    Share this post


    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now